A bank of irrigation valves on a manifold sitting in an open trench.

Irrigation systems, repairs and re-zoning

New valves, lines and heads, or repairs and re-zoning of the system you already have.

Irrigation, in detail.

Every yard we build gets its water sorted out before the stone goes down, because the one thing you cannot do later is run a line under a finished patio. We install complete systems from the point of connection: backflow, valve manifolds in boxes you can actually open, mainline and lateral lines trenched to proper depth, sleeves under every hard surface, rotors and sprays matched so one zone is not flooding while another stays dry, and drip in the beds where a spray head would only wet the fence. We also work on systems that are already in the ground. Most of those calls are the same handful of problems: a zone that will not shut off, a valve that has silted up, heads buried under years of mulch, a controller nobody has reprogrammed since the day it went in, or a lawn that was replaced with planting and now has rotors soaking the wrong thing. Re-zoning an old system around a new landscape usually costs less than people expect.

Open trenches running across a back yard with white PVC laid in, a worker at the far end.
A newly planted citrus tree in fruit against a stucco wall, watered in after planting.

What is in it.

Everything below is part of the irrigation work, not an extra line on the invoice.

  • Full systems: backflow, valves, mainline, laterals, heads and drip
  • Sleeves under driveways, patios and walkways before the paving goes in
  • Zones planned so plants with the same water needs run together
  • Smart and standard controllers, wired and programmed
  • Repairs, leak finding, valve and head replacement and re-zoning

How it runs.

  1. Find out what is thereWe locate the valves, run every zone and see what is actually working before quoting anything.
  2. Plan the zonesPlants that drink the same amount go on the same valve, so no zone is watering for someone else.
  3. Trench and sleeveLines go in at depth and sleeves go under anything that is about to be paved over.
  4. Test and setEvery head is adjusted while its zone is running, then the controller is programmed and shown to you.

On site.

Trenches open across a back yard with the PVC grid laid in them.

Questions about irrigation.

My system is old. Repair it or replace it?

If the mainline and the valves are sound, repairs and new heads usually get you there. Once you are replacing valves one at a time every season, a new manifold costs less over a couple of years. We will say which one you are looking at.

Can you add drip to beds that have spray heads now?

Yes, and it is one of the most worthwhile changes in a planted yard. The spray head is converted at the riser and drip line is run through the bed under the mulch.

Will you have to dig up the new patio to get water to the far side?

Not if sleeves went in first. On our own jobs we put them under every hard surface as a matter of course, even where nothing is planned, because an empty sleeve costs almost nothing and saves a demolition.

Call (949) 257-7783 Text us